An advanced interface for mid-sized multicopters using the 59/10 or 12mm dual rail mounting system (Tarot 650 etc.). If your multicopter has vibrations which you have been unable to remove, this combination...
Replacement lower plate (2.5mm thick carbon fiber). Can attach to 5208 yaw motor or two 16mm tube clamps.
Into DIY or you've somehow broken your existing hanging brackets, here is where you can purchase the hanging brackets on their own as a pair. Designed for dual rail systems where the gap between the rails...
Deluxe 3 Axis Mount V2 : Front Leg Brace (2.0mm carbon fiber)
All new design of the original dual battery interface for the F550. If you own the F550 interface with 16 dampers you can now add these two trays to allow you to attach twoLiPo batteries to the interface,...
Replacement pitch right arm (2.0mm thick carbon fiber). Includes 4 replacement pegs. Specifically for the LD-Power 4008-57 Gimbal Motor Also designed for EZ-Gimbal With A Twist
Replacement pitch right arm (2.0mm thick carbon fiber). Includes 4 replacement pegs. Also designed for EZ-Gimbal With A Twist
EZ-Gimbal pitch support screw outer disk Also designed for EZ-Gimbal With A Twist
Replacement pitch top brace (2.0mm thick carbon fiber). NOT designed for EZ-Gimbal With A Twist
Replacement left roll arm (2.0mm thick carbon fiber). Includes 4 replacement pegs. Also designed for EZ-Gimbal With A Twist
Replacement right roll arm (2.0mm thick carbon fiber). Includes 4 replacement pegs. Also designed for EZ-Gimbal With A Twist
An advanced interface for the DJI F550 center hub which connects to the outside rings of the lower plate. It uses the same parts as the 59/10 or 12mm interface with dampers, allowing you to change over...
Twist with refinements.... Presenting the EZ-Gimbal Pro With A Twist. You can now rotate your camera into a portrait orientation to enable portrait photography and panoramas. Due to the unique three axis...
And now for something completely different.... Well, not completely different, but a significant change in how you can set the COG of your camera on the gimbal. The pitch assembly has two plates which...
Possibly the lightest NEX sized camera gimbal you will find on the market. Completely assembled with two brushless motors, basic 59/12mm mount and control board/IMU, the entire gimbal weighs only 400g...
Designed for heavier gimbals using 550-800g cameras, this mount provides an easy to balance, rigid support for your gimbal with a well braced iPower 6208H-150T yaw motor (24N22P). Also included is a 12...
Designed for heavier gimbals using 550-800g cameras, this mount provides an easy to balance, rigid support for your gimbal with a well braced GB5010EN yaw motor (24N28P). The main benefits of using a motor...
For those wanting rigid support legs that rotate with the camera gimbal yaw this tripod leg mount provides you with lightweight legs that will never get in your shots. Based on the standard 6208 Pro Mount,...
If you are after a simple and lightweight 2 axis mount for your multicopter, this mount is it. Highly adjustable and easily customised to work with your multicopter. Simply pair it up with one of the interface...
If you find that you need to use extra carbon fiber washers to raise your camera up during balancing on the NEXt-Gimbal, you may need a longer 1/4" screw to pass through all four washers. This 15mm camera...